* Added T-DISPLAY-S3 i8080 support for more than 33 data pins (#2296)
* Modified the ESP32-S3 I8080 interface's support for data pins above 33 pins.
* Added T-DISPLAY-S3 support
* Update Setup206_LilyGo_T_Display_S3.h
* Eliminate need for TFT_DATA_PIN_OFFSET_EN in setup file
* Update TFT_eSPI_ESP32_S3.h
* Update User_Setup_Select.h
* Add new init sequence for LilyGo T Display S3
Co-authored-by: Micky <513673326@qq.com>
// For RP2040 processor and 8 or 16 bit parallel displays:
// The parallel interface write cycle period is derived from a division of the CPU clock
// speed so scales with the processor clock. This means that the divider ratio may need
// to be increased when overclocking. I may also need to be adjusted dependant on the
// display controller type (ILI94341, HX8357C etc). If RP2040_PIO_CLK_DIV is not defined
// the library will set default values which may not suit your display.
// The display controller data sheet will specify the minimum write cycle period. The
// controllers often work reliably for shorter periods, however if the period is too short
// the display may not initialise or graphics will become corrupted.
// PIO write cycle frequency = (CPU clock/(4 * RP2040_PIO_CLK_DIV))
//#define RP2040_PIO_CLK_DIV 1 // 32ns write cycle at 125MHz CPU clock
#define RP2040_PIO_CLK_DIV 2 // 64ns write cycle at 125MHz CPU clock
//#define RP2040_PIO_CLK_DIV 3 // 96ns write cycle at 125MHz CPU clock
Sprite class uses TFT_eSPI setBitmapColor - fn deleted
Small performance improvement to RP2040 SPI PIO
Typo corrections
Correct (unused) tft_Write_32 for STM32
Update HX8357D rotation code
Enable software reset for ILI9486
Add preliminary RM68120 support
In setup add the following lines:
// If green and blue swapped on display then change the RGB colour order
// Only uncomment ONE of the following options
#define TFT_RGB_ORDER TFT_RGB // Red-Green-Blue
//#define TFT_RGB_ORDER TFT_BGR // Blue-Green-RED
Add ILI9225 support
Add viewport feature to Sprites
Rationalise common TFT_eSPI and Sprite functions and variables to use inherited functions width(), height(), rotation(), write(), pivot, cursor, swapBytes.
Simplified driver ST7789_2_DRIVER not supports 135 x 240 display.
This will not fix#763 since user specifies alternative ST7789_DRIVER which already supports 135x240 displays.
The SSD1963 support has been tested with a 480x800 pixel display from Buy Display.
Support for reading an ST7796 SPI display has been added.
pushToSprite added to keywords list.
#740: To avoid ambiguity the pushSprite for writing a sprite to another sprite has been renamed pushToSprite
#704: Change to 18 bit colurs for SSD1963 with SPI interface
Remove outdated TFT_SPIFFS_Jpeg example
