Icom users, who use the K9JM CI-V router to protect their PW-1
amplifiers from damage due to Icom's broken CI-V protocol handling,
require a 1s delay after opening the serial port. This is due to the
router using an Arduino & Arduino USB adapter that employs a
bootloader which holds the RS-232 interface for 1s after reset (DTR
releases reset). Hamlib already has a retry and timeout mechanism
which was set to 3 and 200ms respectively for most Icom rigs. This
change increses that timeout to 1s. The increaased timeout will have
little or no impact on clients as it only comes into play if there is
a problem.
The Icom IC-7100 back end added this enum instead of using the extant
RIG_PTT_RIG enum. Also the rig_get_ptt() implementation didn't handle
it and errored out.
Note: RIG_PTT_SERIAL_CAT was added in commit
e9ee671149 - N0NB
With Icom rigs that use MAIN?SUB VFOs there is a trade off when
setting the mode or frequency of the "other" VFO. Untill now Hamlib
uses the XCHG VFO command to address the "other" VFO. This has some
advantages, particularly it preserves the selected VFO and it
preserves memory mode of either VFO. The disadvantage is that any
split command causes the Rx to glitch when the VFO/MEMs are exchanged.
I have added a config parameter for Icom rigs called "no_xchg" which
forces the direct addressing of VFOs to set split mode/frequency. It
is a boolean option with a default of "0" (false) which equates to
prior behaviour. Setting it to "1" (true) will make the backend use
change VFO commands to set the "other" VFO. This means that TX on
"SUB" in split is assumed, that both are in VFO mode (not MEM), and
set/get split functions will leave the MAIN VFO selected.
From Martin, CT1IQI:
"Several programs under Linux rely on Hamlib for control. I wanted to
try WSJT-X (digital modes like JT65) and found that my new IC-7100 was
not yet supported, also after having compiled the current git version of
Hamlib and having compiled WSJT-X against that.
So I added a IC-7100 by taking the ic-7200 and 7420 rig files as
example, be it without going (yet) through all of the very many commands
the ic-7100 supports.
This produced the situation where there was communication, e.g. setting
and reading frequencies, but the PTT control did not work. I debugged
that to actually the lack of a PTT mode in Hamlib that uses serial and
CAT at the same time; currently PTT per 'serial' seems equivalent to
toggling certain RS232 pins but not to any serial command level. So I
added a RIG_PTT_SERIAL_CAT mode for PTT control. Now the wsjt-x program
works nicely with the ic-7100 and controls both frequency and PTT via
the single USB cable."
Signed-off-by: Nate Bargmann <n0nb@n0nb.us>
