Added new function that sketch can call to convert raw ADC x and y
values to calibrated screen coordinates:
tft.convertRawXY(&x, &y);
Redunced required number of SPI transfers needed to read raw values.
Changed mode so PENIRQ pin is enabled so users sketch can read this
signal (if needed).
See issue #279.
Fixed bug where wrong wodth was returned for 1bpp Sprite
Improved speed for copying a 1bpp Sprite into another 1bpp Sprite (
affects Sprite pushImage() function only)
Added option to setup for colour inversion
Arduino library manager picked up the wrong release.
This version raise is to forece a new release to be recognised. Releases
1.3.2 and 1.3.3 have been deleted.
// For ST7789 ONLY, define the colour order IF the blue and red are
swapped on your display
//#define TFT_RGB_ORDER TFT_RGB // Colour order Red-Green-Blue
//#define TFT_RGB_ORDER TFT_BGR // Colour order Blue-Green-Red
Remove legacy changes for double buffered SPI
Eliminate unecessary ESP32 SPI read/modify write
Eliminate two stage control bit changes (may impact some diplays with
setup/hold timing and show ESP32 hardware register bug?)
Add single register write for CS and DC command
Make setAddrWindow smarter (as used in previous AVR library)
Improve compatibility with GFX sketches
Re-arrange comments slightly to improve positioning
The library supported 240x240 ST7789 displays only which require an 80
pixel offset in rotation 2 and 3
The library now also supports the 240x320 display which has a different
RGB colour order.
Four new examples have been added to show different methods of rendering
the anta-aliased fonts. A few minor bugs have been corrected associated
with the font rendering. drawNumber and drawFloat handle fixed width
mono fonts with no digit movement.
This is stage one of support for ePaper displays from Waveshare.
Examples for 1 bit per pixel Sprites and 2 or 3 colour ePaper displays
to follow soon.
Add interface driver macro
Add 8 bit parallel support
Add 8 bit parallel read support
Add ILI9481, ILI9488 and HX8357D drivers
Update version and ReadMe
Update Create_Font processing sketch
Add slightly narrower alternative font 8
getTouch accepts a third optional pressure threshold, default is 600,
increasing means harder presses are needed.
getTouch(uint16_t *x, uint16_t *y, uint16_t threshold = 600);
